How is CBD solventless concentrate made?

The cannabinoid CBD has been widely researched and finds intriguing uses for those with anxiety, epilepsy, and various other conditions. CBD does not have any psychoactive effects, and it is considered one of the most secure substances on the market today. However, as a natural product, it requires extraction to be rendered into a useable form. The process usually relies on solvents such as alcohol to separate CBD from its cannabis herbaceous material. If you want to get high-quality CBD, here is a step-by-step guide to making solventless CBD concentrates.

Decarboxylate your weed

Decarboxylation is a chemical reaction that releases carbon dioxide while removing a carboxyl group (CO2), leaving behind only activated cannabinoids like THC (tetrahydrocannabinol) and CBD (cannabidiol). For instance, the process of getting solventless concentrate California-based starts when you expose hemp to moderate heat for around twenty minutes. This process allows all of the cannabinoids to activate and become as potent as they can be.

Sift your kief/trim

The next step is to remove any unwanted plant matter from your weed, leaving you with only manicured, potent kief or trim. Collect your chosen material, and sift it through a mesh strainer. Make sure you do this over a clean surface to collect the siftings for re-use later on.

Pre-heat your oven to 165 degrees Celsius.

Next, pre-heat your oven to 165 degrees Celsius to increase the chances of getting higher THC content. That will also help the decarboxylation process, which converts raw cannabinoids into activated forms.

Prepare your oven for decarboxylation

When you begin this process, the room temperature should be between 15-25 degrees Celsius, so you will want to turn your oven on pre-heating a little earlier than usual. To ensure that all of the weed material gets a chance to get to that lukewarm temperature, it’s best if you don’t open the oven while it’s heating up.

Decarboxylate your weed

Now that your oven is ready put your cannabis material in the oven for 15 minutes. Make sure it’s not too close to the heating element so that it doesn’t burn. Remove your weed from the oven and allow it to cool down.

While you wait for the decarboxylation process to complete, you can prepare the rest of your kitchen for cooking with cannabis. Cover any surfaces you don’t want re-infused with THC later on, such as carpets and curtains. Turn off any extractor fans and heating vents or halogen lights in the room, too. Once completed, each batch can be tested for THC content using Gas Chromatography-Mass Spectrometry (GC/MS) before being packaged into containers for distribution.

Collect your decarboxylated material

After 15 minutes:

• Remove your weed from the oven and allow it to cool down.
• Once it has cooled, sift the material through a coffee grinder or other fine grinder to make as much kief as possible.
• Don’t use anything with too large of a digestive system, though, as this will create more waste later on.

You can extract CBD from the plant material using conventionally and solventless extraction methods. Depending on how pure the final product is, these different methods can significantly impact what you eventually use it for, whether as a topical ointment or as medication.